How to put your Cabrinha Fireball Spreader bar on to your DaKine Harness.

If you look at this spreader bar is clearly different.  The hook is  shorter and is flipped to ensure that the Fireball system will not fall out.  Below are step-by-step instructions on how to set up your Fireball system to a DaKine harness. 

First, you will need to take the DaKine spreader bar off.  We will start with the clip side of the harness or the left side.

To do this remove the nylon straps from the plastic clips on both the top and the bottom.  Pull them through so that the clip is completely off. 

 Unhook the new spreader bar hook from the Fireball spreader bar.  Remove the nylon strap that is in the bottom hole. 

Starting with the top of the strap on your DaKine harness, feed the strap through the lower top hole of the hook, starting from the bottom then going to the top as shown.  *Be sure to keep the nylon strap under the the hook to ensure that you will still be able to use it. 

Feed the strap under the neoprene pouch and into the plastic clip starting from the back.  Do the same to the lower nylon strap. 

Next, take the Dakine spreader bar off of the harness completely.  To do this, follow steps 1 and 2.  Feed the nylon straps through the plastic clips then out of the spreader bar until it is no longer attached to the harness. 

Then take the Fireball spreader bar and remove the nylon strap. With hook facing up, run the top strap through the lower top hole, in the spreader bar. Making sure you start from the bottom.

Then as you did on the left side, run it under the neoprene pouch and into the plastic clip. Do the same to the bottom nylon strap. Put on the harness and tighten until it fits correctly and comfortably. That’s it.  Now you are ready to use your new 2017 Cabrinha Fireball.